Has anyone dealt with reconstitution calculator?

zoe_NC said:

Concentration choice is a precision decision, not a preference.

That is correct as far as it goes, and here is where it stops going. Dead space is the answer to the missing dose. A fixed-needle insulin syringe holds a few microlitres in the hub and needle after the plunger bottoms out, and on small draws that is a measurable percentage of every dose. Across ten draws it adds up to most of an eleventh, which is exactly the "nine draws from a ten-dose vial" complaint. Luer-lock syringes are worse; low-dead-space fixed-needle designs are better.

zoe_NC said:

Concentration choice is a precision decision, not a preference.

I am going to disagree with reconstituting low as a general rule. More diluent, more punctures, more in-use days at room temperature, and the stability trade-off is real. Precision is not the only variable being optimised.

Taking the question as asked, rather than the general version of it. Do it in two steps and it stops being confusing. First concentration: 10mg into 2ml is 5mg/ml. Then volume: a 0.5mg dose is 0.5 ÷ 5 = 0.1ml. Then units, and this is where people go wrong — a U-100 syringe is graduated in hundredths of a millilitre, so 0.1ml is 10 units. The word "units" has nothing to do with milligrams; it is a volume marking that exists because insulin happens to come at 100 units per ml.

DanielChem_CHI said:

Dead space is the answer to the missing dose.

Mine went the same way, slower. The detail I would add is minor and it is already implied above.