Air bubbles in syringe — my results so far

Short answer first, then the reasoning. Concentration choice is a precision decision, not a preference. Reconstitute high and every dose is a tiny volume where one unit of syringe error is a large fraction of the dose. Reconstitute low and you get more graduations per dose, so the same hand tremor costs proportionally less. Against that, more diluent means more benzyl alcohol and a shorter comfortable in-use window.

mike.trainer_LA said:

Concentration choice is a precision decision, not a preference.

Agreeing with mike.trainer_LA, and the qualification matters more than the agreement. The arithmetic is right and one caveat matters: a U-40 syringe changes the markings, not the volumes. If someone hands you U-40 and you read it as U-100 you will be 2.5 times out, and that error has a direction — it is always an overdose.

marco_milano said:

I reconstituted a 10mg vial with 2ml of bacteriostatic water and I want someone to check my unit arithmetic before I draw anything, because I keep…

Same position here, arrived at the long way round. Dead space is the answer to the missing dose. A fixed-needle insulin syringe holds a few microlitres in the hub and needle after the plunger bottoms out, and on small draws that is a measurable percentage of every dose. Across ten draws it adds up to most of an eleventh, which is exactly the "nine draws from a ten-dose vial" complaint. Luer-lock syringes are worse; low-dead-space fixed-needle designs are better.

Clinical perspective, offered as context rather than as advice.

For anyone reconstituting dosing arithmetic peptides: the water-to-powder ratio determines your concentration. Here's my reference:

More water = easier to measure small doses but vial runs out faster. Find the balance that works for your dose.