Steady-state concentrations across dose tiers — need advice

This one has a reasonably settled answer, so here it is. Do it in two steps and it stops being confusing. First concentration: 10mg into 2ml is 5mg/ml. Then volume: a 0.5mg dose is 0.5 ÷ 5 = 0.1ml. Then units, and this is where people go wrong — a U-100 syringe is graduated in hundredths of a millilitre, so 0.1ml is 10 units. The word "units" has nothing to do with milligrams; it is a volume marking that exists because insulin happens to come at 100 units per ml.

Dr.GutHealth said:

Do it in two steps and it stops being confusing.

Agreed, and it is worth saying that rounding to the nearest whole unit is usually acceptable at maintenance doses and is not acceptable at the bottom of a ladder, where one unit can be a fifth of the intended dose.

Ask again with the specifics and you will get a better answer than this one.

cory_ATX said:

Two of us with identical vials and identical diluent arrived at different unit counts, which means one of us has a conceptual error rather than a…

Same position here, arrived at the long way round. Concentration choice is a precision decision, not a preference. Reconstitute high and every dose is a tiny volume where one unit of syringe error is a large fraction of the dose. Reconstitute low and you get more graduations per dose, so the same hand tremor costs proportionally less. Against that, more diluent means more benzyl alcohol and a shorter comfortable in-use window.

Adding the clinical framing, because it changes how the question reads.

Reconstitution tip for anyone mixing dosing arithmetic from lyophilized powder: use bacteriostatic water, NOT sterile water. The benzyl alcohol in BAC water preserves multi-dose vials for up to 28 days.

Inject the water slowly down the side of the vial. NEVER shake — gentle swirling only until fully dissolved. Should be crystal clear with no particles.