Dr.ObesityMed said:Worth answering the question that was asked rather than the one behind it.
Second this. Posting only so the count is not one.
Dr.ObesityMed said:Worth answering the question that was asked rather than the one behind it.
There is a second half to this that has not been said yet. It helps to ask what evidence would change your mind before you look at any. If nothing would, the discussion is not about evidence, and it is better to say so early than to spend nine posts discovering it.
If somebody has the primary source to hand I would rather cite it than paraphrase it.
One concrete data point for the thread. If you are comparing against somebody else’s result, check that you are comparing the same measurement taken the same way. Most of the apparent contradictions in these threads dissolve at that step.
Trusted third-party HPLC & mass spectrometry analysis. Verify peptide purity with the lab the community relies on. Independent. Accurate. Transparent.
Verify Your PeptidesEst. 1998. The synthesis house behind the vials you send for testing. ISO 9001 and cGMP certified, 1,500+ staff, batch-specific COA with every order.
Browse GL BiochemFollowing on from Dr.ObesityMed — and this may be the naive question:
What would you measure differently if you were starting again?
Closing the loop on my own question.
Update: the thing I was blaming turned out not to be the cause. Leaving the original post as written rather than editing it, so the mistake stays visible for whoever searches this next.