Has anyone dealt with dumb question - what is bacteriostatic water exactly?

NurseLeah_Nash said:

Regarding dosing arithmetic multi-dose vial contamination prevention: after reconstituting, I wipe the vial stopper with a fresh alcohol swab before…

Reconstitution tip for anyone mixing dosing arithmetic from lyophilized powder: use bacteriostatic water, NOT sterile water. The benzyl alcohol in BAC water preserves multi-dose vials for up to 28 days.

Inject the water slowly down the side of the vial. NEVER shake — gentle swirling only until fully dissolved. Should be crystal clear with no particles.

ben_calgary said:

The arithmetic is right and one caveat matters: a U-40 syringe changes the markings, not the volumes.

This is exactly what I could not find anywhere else. I will report back once I have actually tried it.

NurseLeah_Nash said:

Regarding dosing arithmetic multi-dose vial contamination prevention: after reconstituting, I wipe the vial stopper with a fresh alcohol swab before…

Quick syringe math for dosing arithmetic dosing: if your vial is reconstituted at 5mg/2mL, that's 2.5mg/mL. For a 0.25mg dose you need 0.1mL = 10 units on an insulin syringe.

I keep a chart on my fridge:

• 0.25mg = 10 units
• 0.5mg = 20 units
• 1.0mg = 40 units
• 1.25mg = 50 units

Always double-check your concentration before drawing up!

NauseaFreeNow said:

Two of us with identical vials and identical diluent arrived at different unit counts, which means one of us has a conceptual error rather than a…

For anyone reconstituting dosing arithmetic peptides: the water-to-powder ratio determines your concentration. Here's my reference:

More water = easier to measure small doses but vial runs out faster. Find the balance that works for your dose.

Moderator note: reminder that nothing in this thread is medical advice, and that clinical claims need a source.